Motorola DCT2000 Installation Manual page 20

I n s t a l l a t i o n
This section provides instructions for installing and cabling the DCT 2000. To complete the
installation, you must:
§
Connect the cables
§
Supply power to equipment
§
Download configuration information and software
§
Run operational check and diagnostics
Before you begin, review the installation instructions, gather the required items, and complete
the tasks listed below:
§
Determine if the subscriber's system requirements include an A/B In, RF Bypass, Dual
A/B-RF Bypass module, or a STARFONE module. These options can be installed before
leaving the office. Installation instructions are provided with these modules.
§
Verify that you have 75-ohm coaxial cables with F-type connectors and RCA baseband
phonotype cables.
§
Determine if you are connecting the DCT 2000 to a standard TV or a composite (baseband)
monitor.
§
Place the DCT 2000 on a smooth, flat surface and remove any obstructions that could
interfere with the free flow of air over, under, or around it. Advise the subscriber not to
place anything on top of the unit.
To install the DCT 2000:
If an add-on module is required and it was not previously installed, do that now. When
installed, verify that the appropriate configuration information has been downloaded via
the access control system.
Determine if you are connecting the DCT 2000 to a conventional TV or to a monitor. To
install the video connection:
§
For a conventional TV, use a 75-ohm coaxial cable with F-type connectors.
§
For a monitor, use an RCA phono cable to connect the
Locate the cabling diagram that matches the subscriber's configuration requirement.
Connect the cables as illustrated in the diagram.
Perform the basic operational check in this section after the DCT 2000 is installed.
connector to the monitor.
VIDEO