Electrical Requirements - BOSER Technology BBS-1080S Manual

Downloaded from Elcodis.com electronic components distributor
A.3 Electrical Requirements
The subject power supply will meet all electrical specifications below,
over the full operation temperature range and dynamic load regulation.
Output Rating
Output Nominal Regulation Ripple/Noise Min.
1 +3.3V +/-5%
2 +5V +/-5%
3 +12V +/-5%
4 -12V +/-10%
5 +5VSB +/-5%
NOTE: -12V, +3.3V, +5V, +12V will have the regulation to +/-10% when all load take off.
The +3.3V and +5V total output shall not exceed 61 watts. The +3.3V,
+5V and +12V total output shall not exceed 165 watts and the total
output for this subject power supply is 180 watts. Ripple and noise
measurements shall be made under all specified load conditions
through a single pole low pass filter with 20MHz cutoff frequency.
Outputs shall bypassed at the connector with a 0.1uF ceramic disk
capacitor and a 10uF electrolytic capacitor to simulate system loading.
Load Capacity Specifications
Load STM
All Max HHHH
+5V Max other Min LHLL
+3.3V Max other Min HLLL
+12V max other Min LLHL
All Min LLLL
Hold Up Timer (@Full Load)
115V/60Hz: 17mSec. Minimum.
230V/50Hz: 17mSec. Minimum.
Output Rise Time (10% to 90% of Final Output Value, @Full
Load)
115V-rms or 230V-rms; +5Vdc: 20mx Max.
50mV 0.3A
50mV 0.3A
120mV 1.5A
120mV 0.0A
50mV 0.0A
+3.3V +5V +12V
4.5A 9.0A 9.0A
0.3A 12.0A 1.5A
16.8A 0.3A 1.5A
0.3A 0.3A 10.0A
0.3A 0.3A 1.5A
Max.
16.8A
12.0A
10.0A
0.8A
2.0A
-12v
0.8A
0.0A
0.0A
0.0A
0.0A
73