Get Started - Motorola MOTONAV TN20 User Manual

get started

To get started, you need to turn on your MOTONAV TN20 and configure
initial device settings:
1 Press and hold Power button to turn on the device until the display
becomes active.
After a few moments, a configuration wizard appears to provide
step-by-step setup instructions.
2 Set your language preference and tap OK.
3 Review Warning message and tap OK.
Review End User License Agreement (EULA), then tap I Agree checkbox
4
and OK.
5 Set your time zone settings and tap OK.
6 Set your preferred measurement units and tap OK.
8
get started
Verify that the device displays your current location on the map view
7
screen like shown below.
If you see Finding Your GPS Location at bottom of the screen, the
MOTONAV TN20 is searching for GPS satellites. Move device to an open
location with a clear view of the sky and wait a few minutes to obtain
satellite GPS signal. When obtained, your current location appears on the
map view screen.
Initial configuration of your MOTONAV TN20 is now complete!
9