Regency Greenfire GF1500L NG-2 Manual page 2

GF1500L-2 Gas Fireplace
CLEARANCES
The clearances listed below are minimum distances unless otherwise stated:
A major cause of chimney related fires is failure to maintain required clearances (air space) to combustible materials. It is of the greatest
importance that this fireplace and flue system be installed only in accordance with these instructions.
Caution Requirements
The top, back and sides of the fireplace are defined by
standoffs. The metal ends of the standoff may NOT be
recessed into combustible construction.
Clearance:
A: Mantel Height (min.)
B: Sidewall (on one side)
C: Ceiling
(room and/or alcove)
D: Mantel Depth (max.)
E: Alcove Width
F: Alcove Depth
G: From Floor
Note:
D
A
G
2 | Greenfire GF1500L-2
Dimension Measured From:
254 mm Top of Fireplace Opening/Hot Air Outlet
152 mm Side of Fireplace Opening/Hot Air Outlet
1162 mm Top of Fireplace Opening/Hot Air Outlet
730mm Above Fireplace Opening/Hot
305mm
Air Outlet
1524 mm Sidewall to Sidewall (Minimum)
914 mm Front to Back Wall (Maximum)
617 mm Top of Fireplace Opening/Hot Air Outlet
0 No hearth required
F
B
E
Installed Close
to Floor
F
if these clearances (air space) to combustible materials are
not adhered to. It is of greatest importance that this fireplace
and flue system be installed only in accordance with these
E
Alcove
WARNING
Fire hazard is an extreme risk
instructions.
Flue Clearances to Combustibles
Horizontal - Top
Horizontal - Side
Horizontal - Bottom
Vertical
IMPORTANT: If installing a television above
this appliance, the television must be either
fully recessed into the wall above the
fireplace and or have a mantle below the
television. If the television is left unprotected,
the extreme heat being emitted from this
appliance will result in damage to the
television. See clearance requirements for
both mantle (page 9) and or enclosing the
top of the appliance (page 11 (D) dimension).
Installed close
to ceiling.
76mm
51mm
51mm
51mm