Next Wave Automation Digital Duplicator Manual page 8

 The "Max Z Depth" parameter defines the lowest depth permitted of
the scan. Anything lower will appear flat.
Running the Digitizer
 Secure the item you want to scan on the CNC bed.
 If connecting the Digitizer when power is off to the unit, make sure to
press and hold on the digitizer end (ruby tip) while powering the unit
up. Failure to do this will put the controller into Firmware Update
mode.
o Digitizer can also be plugged into the unit after power has
been applied.
March 30, 2017 8 | P a g e