Eliminating/Returning The Normal Arm/Disarm Chirps; Alarm Dash Led Indicators; Alarm Siren Chirp Indication; Alarm Parking Lamp Indications - Code Alarm CA 310 Owner's Manual

ELIMINATING/RETURNING THE NORMAL ARM/DISARM CHIRPS

You can selectively eliminate the normal arm & disarm chirps using the valet/
override switch, following these steps.
1) Turn the ignition key ON the OFF.
2) Within 10 seconds of turning the ignition key OFF, press and release the
valet/override switch 3 times.
3) If, before step 1,the chirps were ON, then you will hear 2 short chirps,
which indicates the chirps are turned OFF.
4) If, before step 1, the chirps were OFF. then you will hear 1 short chirp,
which indicates the chirps are turned ON.
5) Whenever the system's power has been disconnected, the chirps will be
ON when power is reconnected.
SYSTEM FUNCTIONS AT A GLANCE

ALARM DASH LED INDICATORS

RAPID FLASHING
SLOW FLASHING
OFF
ON SOLID
4 FLASH...PAUSE
3 FLASH...PAUSE
2 FLASH...PAUSE

ALARM SIREN CHIRP INDICATION

1 CHIRP*
2 CHIRPS*
3 CHIRPS
4 CHIRPS
CONTINUOUS

ALARM PARKING LAMP INDICATIONS

1 FLASH
2 FLASH
3 FLASH
CONTINUOUS FLASH
CA-310
= PASSIVE ARMING
= ARMED
= DISARMED
= VALET MODE
= INTRUSION SHOCK SENSOR
= INTRUSION DOOR
= INTRUSION HOOD OR TRUNK
= ARM
= DISARMED
= ARMING WITH ENTRY POINT OPENED
= DISARM AFTER INTRUSION
= ALARM TRIGGERED
= ARM
= DISARM
= DISARM AFTER INTRUSION
= TRIGGERED
Page 5
128-6530
5 of 10