Stiga R72 Li 48 V1 Operator's Manual page 69

PROBLEM
The icon in fig. 7.E remains ON and
battery LEDs 1, 4 and 5 flash.
The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1 and 3
flash.
The icon in fig. 7.E remains ON and
battery LEDs 1, 3 and 5 flash.
The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1, 2 and
4 flash.
The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1, 2, 4 and
5 flash.
The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1, 2, 3 and
5 flash.
The icon in fig. 7.E remains ON and
battery LED 2 flashes.
Cause
Current overload to cutting means
caused by:
Work conditions too demanding.
Obstructions that prevent rotation of
the cutting means.
The cutting means assembly is full
of grass.
Cutting means motor over-
temperature caused by:
Work conditions too demanding.
Cutting means motor stall caused
by:
Work conditions too demanding.
Obstructions that prevent rotation of
the cutting means.
The cutting means assembly is full
of grass.
Drive motor over-temperature
caused by:
Drive motor under stress.
Slope too steep .
Excessive mud on the wheels.
The machine starts with the drive
pedal not released (not in neutral
position).
Drive engagement/disengagement
lever in drive disengaged position.
Battery detection/communication
error.
EN - 9
Remedy
Reduce forward speed.
Increase the cutting height.
Remove the obstructions.
Clean the cutting means assembly.
Turn off the machine, wait for at least 5
minutes and then restart it.
Reduce forward speed.
Increase the cutting height.
Reduce forward speed.
Increase the cutting height.
Remove the obstructions.
Clean the cutting means assembly.
Switch off the machine and wait for at
least 5 minutes before repeating the
starting procedure.
Reduce forward speed.
Reduce speed and check the slope of
the ground where you are working.
Make sure that the wheels are not
blocked and clean as needed.
Switch off the machine and repeat the
starting procedure only after having
checked that the drive pedal is in the
neutral position (pedal released).
Check the position of the drive
engagement/disengagement lever
and, if necessary, return it to the drive
engaged position.
If the problem persists, contact a
Service Centre.
Switch off the machine and repeat the
starting procedure.
Check the correct mounting/installation
of the batteries in their respective slots.
If the problem persists, contact a
Service Centre.