Setting The Audio Delay - Felston HD940 Owner's Manual

Press and release
blank.
Setting the Audio Audio Delay
So you can achieve perfect lip So you can achieve perfect lip-sync correction, the HD940 allows
you to set the audio delay in steps of just 1 millisecond (1 ms), you to set the audio delay in steps of just 1 millisecond (1 ms), you to set the audio delay in steps of just 1 millisecond (1 ms),
i.e. 1/1000th of a second. In
mode allows steps of an even smaller allows steps of an even smaller
The minimum delay you can select is 0 ms, i.e. no delay. The The minimum delay you can select is 0 ms, i.e. no delay. The The minimum delay you can select is 0 ms, i.e. no delay. The
maximum audio delay you can select is between 340 ms and maximum audio delay
999 ms depending on the type of HDMI audio signal. 999 ms depending on the type of HDMI audio signa
To increase the audio delay in steps of 1 ms, press To increase the audio delay in steps of 1 ms, press To increase the audio delay in steps of 1 ms, press
holding down this button, the delay will increase quickly until holding down this button, the delay will increase quickly until holding down this button, the delay will increase quickly until
you release it. The amount of delay will be shown on
The delay will only activate once you have stopped changing the The delay will only activate once you have stopped changing the The delay will only activate once you have stopped changing the
delay.
Whenever the audio delay is changed, the audio will mute for a Whenever the audio delay is changed, the audio will mute for a Whenever the audio delay is changed, the audio will mute for a
short period. This is normal operation. short period. This is normal operation.
To decrease the delay To decrease the delay in steps of 1 ms, use
To increase the delay by 10 ms, press To increase the delay by 10 ms, press
be shown on-screen. To increa screen. To increase by another 10 ms, release the
button and press it again (there is no auto-repeat on this button and press it again (there is no auto
button). Decrease the delay by 10 ms by pressing button). Decrease the delay by 10 ms by pressing
same way.
The delay is set independently for The delay is set independently for each input. If the input
changes the delay will revert to the setting that was last used for changes the delay will revert to the
the new input.
Numeric Delay Entry Numeric Delay Entry
The numeric keypad can also be used to set the delay. Simply The numeric keypad can
enter the desired desired delay by pressing the number
a third time and the on-screen display will
sync correction, the HD940 allows
a second. In addition, Fine Delay
The amount of delay will be shown on-screen. The amount of delay will be shown on
1
/ ms.
3
between 340 ms and
. The new delay will . The new delay will
se by another 10 ms, release the
input. If the input
setting that was last used for
be used to set the delay. Simply
screen display will
Delay Adjustment
l.
. By
in the same way. in the same way.
repeat on this
in the
buttons in
17