Table of Contents
Advertisement
• Press
panel, to toggle through inputs A to D
• Or use the discrete input buttons
select the input directly
The Input LED on the front panel indicates which source is
selected. When an active source is selected, after a few seconds
you should see the source image on your TV.
Note: For fully manual input selection, turn IntelliInput off. See
page 36 for more information.
On-Screen Display
When you change input or another setting of the HD940, it will
show the relevant information in the bottom-left corner of the
screen.
To see the current input selection and delay, press
e.g.
Input C
Press
again to clear the on-screen display.
Position of On-Screen Display
You can move the on-screen display between 2 positions, one
close to the bottom-left corner, and one position further in
towards the center (this position is useful if you watch your TV in
"zoom" mode). In addition you can turn off the on-screen display
altogether. You will still be able to set delays and perform all
other functions of the HD940, but there will be no display on
your TV. To toggle between Inner Position, Outer Position,
3
The
button has a different function in Cascade Mode and does not toggle through inputs.
See Cascade Mode on page 27 for more details.
on the remote control, or INPUT on the front
107 ms
3
,
,
and
any time,
to
15
Advertisement
Table of Contents
