Felston HD940 Owner's Manual page 13

Connecting Power
When all connections to the HDMI sockets of the HD940 have
been completed, plug the power cable into the power socket on
the rear of the HD940. Finally plug the power adaptor into a
wall socket.
When power is connected, the HD940 will enter standby mode,
indicated by the Standby LED glowing red.
Switch on your TV and source equipment. Select the HDMI Input
of your TV that is connected to the HD940.
AV Receiver Settings
If you are using an AV Receiver and it has its own audio delay
setting, set this to zero milliseconds. If this is not done then it
may be impossible to adjust the total audio delay low enough to
achieve perfect lip-sync.
13