J1939 to modbus tcp server / rtu slave gateway (52 pages)
Summary of Contents for ICPDAS tGW-700-T Series
Page 1
Series Quick Start V1.0, Oct. 2020 What’s in the box? In addition to this guide, the package includes the following items: tGW-700-T Module x 1 Quick Start x1 (This Document) Related Information tGW Series Product Page: Documentation & Firmware: ...
“Search Servers” on Chapter 5 may not work. (Please contact with your system Administrator) Connect both the tGW-700-T and your PC to the same sub network or the same Ethernet switch. Supply power (+12~+48 V ) to the tGW-700-T. Technical support: service@icpdas.com...
Installing Software on Your PC Install eSearch Utility, which can be obtained from the website: http://www.icpdas.com/en/product/guide+Software+Utility_Driver+eSearch__ Utility Wiring Notes Wiring Notes for RS-232/485/422 Interfaces: : Here, the RS-232 and RS-485 wiring is used as an example. RS-232 Wiring...
Page 4
1) Connect the Modbus device (e.g., M-7022, optional) to the COM1 on tGW-700-T. 2) Supply power to the Modbus device (e.g., M-7022, Device ID:1). Note: The wiring and supply power method depends on your Modbus device. RS-485 Wiring RS-232 Wiring Technical support: service@icpdas.com...
Subnet Mask 255.255.0.0 Gateway 192.168.0.1 4) Contact your Network Administrator to obtain a correct network configuration (such as IP/Mask/Gateway). Enter the network settings and click “OK”. Note: The tGW-700-T will use the new settings 2 seconds later. Technical support: service@icpdas.com...
6) Click the name of tGW-700-T to select it. 7) Click the “Web” button to log in to the web configuration pages. (Or enter the URL address of the tGW-700-T in the address bar of the browser.) Configuring the Serial Port Technical support: service@icpdas.com...
Page 7
(e.g., 19200, 8N2 and Modbus RTU) from the relevant drop down options. Note: The Baud Rate, Data Format and Modbus protocol settings depends on your Modbus device. 4) Click “Submit” to save your settings. Technical support: service@icpdas.com...
Page 8
3) Refer to “Protocol Description” section and type the Modbus command in the “Command” field then click “Send command”. 4) If the response data is correct, it means the test is success. Note: The Modbus command settings depends on your Modbus device. Technical support: service@icpdas.com...