Advertisement
Quick Links
GW-7472 QUICK START
For GW-7472
English/ Dec. 2014/ Ve rsion 2.1
What's in the shipping package?
The package includes the following items:
CA-002
Quick Start Guide
Software CD
GW-7472
(DC connector to
(This Document)
2-wire power cable)
Installing software on your PC
Install GW-7472 Utility:
The software is located at:
Fieldbus_CD:\EtherNetIP\Gateway\GW-7472\Utility
http://ftp.icpdas.com/pub/cd/fieldbus_cd/ethernetip/gateway/gw-7472/utility/
GW-7472 Quick Start
1
Advertisement
Related Manuals for ICPDAS GW-7472
Summary of Contents for ICPDAS GW-7472
- Page 1 GW-7472 QUICK START For GW-7472 English/ Dec. 2014/ Ve rsion 2.1 What’s in the shipping package? The package includes the following items: CA-002 Quick Start Guide Software CD GW-7472 (DC connector to (This Document) 2-wire power cable) Installing software on your PC...
-
Page 2: Connecting The Power And Host Pc
(Please contact with your system Administrator) 3. Check Init/Run switch if it is on Init position. 4. Connect both the GW-7472 and your computer to the same sub network or the same Ethernet switch, and power the GW- 7472 on. GW-7472 Quick Start... - Page 3 Searching the GW-7472 1. Double click the GW-7472 Utility shortcut on the desktop. 2. Click the “Network Scan” button to search your GW-7472. 3. Select “Configure” or “Diagnostic” buttons to configure or test the module GW-7472 Quick Start...
-
Page 4: Module Configuration
Module configuration 1. Double click the GW-7472 Utility shortcut on the desktop. 2. Click the “Network Scan” button to search your GW-7472. 3. Select “Configure” buttons to configure the module 4. After setting, click the “Update Settings” button to finish the... -
Page 5: Network Settings
Item Descriptions: Item Description For configuration of the Address Type, Static IP Address, Network Settings Subnet Mask and Default Gateway of the GW-7472 Please refer to section “4.2.1 Network Settings” Modbus Port For configuration of the Baud Rate Data Sizes... -
Page 6: Module Diagnostic
Module Diagnostic 1. Check Init/Run switch if it is on Run position. 2. Reboot your GW-7472. Then, re- connect it by utility. 3. Click “Diagnostic” button to open diagnostic window. GW-7472 Quick Start... -
Page 7: Related Information
Item Descriptions: Item Description Send UCMM packets or use the Forward_Open service to build UCMM/Forward Open the CIP class 3 connection to communicate with the GW-7472. Class 3 Behavior Please refer to section “4.3.1 UCMM/Forward Open Class 3 Behavior” Forward Open Class1...