ICPDAS tGW-700 series Quick Start Manual

Advertisement

What's in the box?
In addition to this guide, the package includes the following items:
tGW-700 Module x 1
Related Information
 tGW Series Product Page:
 Documentation & Firmware:
 NS-205/NS-205PSE/M-7000 Product Page (optional):
Technical support:
tGW-700 Series Quick Start
Quick Start x1
(This Document)
service@icpdas.com
v1.5, Jan. 2018
CA-002 Cable x1
P1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the tGW-700 series and is the answer not in the manual?

Questions and answers

Summary of Contents for ICPDAS tGW-700 series

  • Page 1 Series Quick Start v1.5, Jan. 2018 What’s in the box? In addition to this guide, the package includes the following items: Quick Start x1 tGW-700 Module x 1 (This Document) CA-002 Cable x1 Related Information  tGW Series Product Page: ...
  • Page 2 “Search Servers” on Chapter 5 may not work. (Please contact with your system Administrator) Connect both the tGW-700 and your PC to the same sub network or the same Ethernet switch. Supply power (PoE or +12~+48 V ) to the tGW-700. Technical support: service@icpdas.com...
  • Page 3 Installing Software on Your PC Install eSearch Utility, which can be obtained from the web site: http://ftp.icpdas.com/pub/cd/tinymodules/napdos/software/esearch/ Wiring Notes Wiring Notes for RS-232/485/422 Interfaces: : Here, the RS-232 and RS-485 wiring is used as an example.   RS-232 Wiring...
  • Page 4 1) Connect the Modbus device (e.g., M-7022, optional) to the COM1 on tGW-700. 2) Supply power to the Modbus device (e.g., M-7022, Device ID:1). Note: The wiring and supply power method depends on your Modbus device.  RS-485 Wiring   RS-232 Wiring   Technical support: service@icpdas.com...
  • Page 5: Configuring Network Settings

    Subnet Mask 255.255.0.0 Gateway 192.168.0.1 4) Contact your Network Administrator to obtain a correct network configuration (such as IP/Mask/Gateway). Enter the network settings and click “OK”. Note: The tGW-700 will use the new settings 2 seconds later.  Technical support: service@icpdas.com...
  • Page 6 6) Click the name of tGW-700 to select it. 7) Click the “Web” button to log in to the web configuration pages. (Or enter the URL address of the tGW-700 in the address bar of the browser.)    Configuring the Serial Port Technical support: service@icpdas.com...
  • Page 7 (e.g., 19200, 8N2 and Modbus RTU) from the relevant drop down options. Note: The Baud Rate, Data Format and Modbus protocol settings depends on your Modbus device. 4) Click “Submit” to save your settings.     Technical support: service@icpdas.com...
  • Page 8 3) Refer to “Protocol Description” section and type the Modbus command in the “Command” field then click “Send command”. 4) If the response data is correct, it means the test is success. Note: The Modbus command settings depends on your Modbus device.    Technical support: service@icpdas.com...

This manual is also suitable for:

Tgw-712iTgw-725i

Table of Contents