Panasonic Lumix DC-TZ200D Operating Instructions Manual page 148

●
If the surrounding temperature is high, or a motion picture is recorded continuously, [
displayed and recording may be stopped halfway through. Wait until the camera cools down.
●
Note that if you perform operations such as zoom, using buttons or dials, while recording a motion
picture, operation noise may be recorded.
●
If Extra optical zoom is used before pressing the motion picture button, these settings will be
cleared, and the recordable area will be changed significantly.
●
If the aspect ratio is different for still pictures and motion pictures, the angle of view will change
when starting to record a motion picture.
When you set [Rec Area] to [
displayed.
●
The zoom speed will be slower than normal during motion picture recording.
●
Depending on the type of the card, the card access indication may appear for a while after
recording motion pictures. This is not a malfunction.
●
ISO sensitivity is set to [AUTO] (for motion pictures) while a motion picture is being recorded. You
can set ISO sensitivity and record motion pictures in Creative Video Mode.
●
The below-mentioned motion picture recording modes are set in the following cases:
[Clear in Backlight]
[Clear Nightscape], [Artistic Nightscape],
[Handheld Night Shot], [Clear Night Portrait]
●
This function is not available in the following cases:
• [Glistening Water], [Glittering Illuminations], [Soft Image of a Flower] (Scene Guide Mode)
• [Rough Monochrome], [Silky Monochrome], [Soft Focus], [Star Filter], [Sunshine] (Creative
Control Mode)
• When [Post Focus] is set
• When using [Time Lapse Shot]
• When using [Stop Motion Animation]
148
], the angle of view setting used for recording motion pictures is
Selected Scene Guide Mode
Recording motion pictures
Recording Motion Picture/4K Motion Picture
Recording mode at the time of
recording motion pictures
Portrait Mode
Low Light Mode
] is