Kenmore 795.7132 Series Use & Care Manual page 39

ICE
Problem
The icemaker is not
making any ice.
The icemaker is not
making enough ice.
Refrigerator was recently installed or icemaker recently connected.
It may take up to 24 hours for each compartment to reach the desired temperature and
for the icemaker to begin making ice.
Icemaker is not turned on.
The ice detecting sensor is obstructed.
Foreign substances or frost on the ice-detecting sensor can interrupt ice production. Make
sure that the sensor area is clean at all times for proper operation.
on.
Connect the r
If your icemaker is e
a clear path between the two sensors.
Rev
amount and result in icemaker issues. (Refer to the Connecting the Water Line section.).
Demand exceeds ice storage capacity.
The icemaker will produce approximately 70-184 cubes in a 24 hour period.
Approximately every six months.
When the water dispenser output decreases.
When the ice cubes are smaller than normal.
Low house water supply pressure.
The water pr
necessary to contact a plumber.
Tubing connecting refrigerator to house supply valve is kinked.
The tubing can kink when the refrigerator is moved during installation or cleaning resulting
future kinks.
Doors are opened often or for long periods of time.
If the doors of the unit are opened often, ambient air will warm the refrigerator which
will prevent the unit from maintaining the set temperature. Lowering the refrigerator
temperature can help, as well as not opening the doors as frequently.
Doors are not closed completely.
If the doors are not properly close
not close correctly or pop open" section in Parts & Features Troubleshooting for more
information.
The temperature setting for the freezer is too warm.
The recommended temperature for the freezer compartment for normal ice production is
Possible Cause & Solution
ecommended:
39
TROUBLESHOOTING GUIDE