Kenmore 795.7132 Series Use & Care Manual page 34

CONNECTING THE WATER LINE
Turn the main water supply on and
is clear.
valve after about one quart of
tubing.
. CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE: Before making the connection to the
refrigerator, be sure that the refrigerator power cord is
not plugged into the wall outlet.
1. Remove th
valve.
2.
Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
3.
Insert the end of the copper tubing into the connec-
tion as far as possible. While holding the tubing,
tighten th
Tubing Clamp
¼ in.
Compression
Nut
Ferrule
(sleeve)
om the water
¼ in. Tubing
Refrigerator
Connection
34
Tighten any connections that leak.
CAUTION: Check to see if leaks occur at the water line
connections.
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below. It
will then begin operation automatically if the icemaker
power switch is in the ON (I) position.