Using Your Refrigerator; Setting The Controls - Kenmore 795.7132 Series Use & Care Manual

SETTING THE CONTROLS

AIRFLOW
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections). The
colder the setting, the longer the compressor will run to
keep the temperature colder. The freezer control adjusts
the cold air from the freezer to the refrigerator.
Setting the freezer control to a lower temperature keeps
more cold air in the freezer compartment to make it
colder.
Cold air circulates from the freezer to the fresh food
section and back again through air vents in the wall
dividing the two sections. Be sure not to block vents while
placing items in your refrigerator. Doing so will restrict
and may cause the refrigerator temperature to
become too warm or cause interior moisture buildup. (See
diagram below.)
Temperature
The Refrigerator Temp Control ranges from 33°F
to 46°F (0°C to 8°C). Press the Refrigerator Temp button
to cycle through the available temperature settings one
increment at a time.
The Freezer Temp Control range is from -6°F to
8°F (-21°C to -13°C). Press the Freezer Temp button to
cycle through the available temperature settings one
increment at a time.

USING YOUR REFRIGERATOR

Diagnostics
18
NOTE: When changing control settings, wait 24 hours
before making additional adjustments. The controls are
set correctly when milk or juice is as cold as you would
like and when ice cream is
either compartment is too cold or too warm, change the
setting one increment at a time. Wait 24 hours for the
change to stabilize before adjusting again.
Dispenser
Some dripping may occur after dispensing water. Hold
your cup beneath the dispenser for a few seconds after
dispensing to catch all of the drops.
NOTE: The dispenser will not work if any door is left
open or if the control lock is engaged.
Accela Ice
When you press the Accela Ice button, the Accela Ice
graphic will illuminate in the display and will
continue for 24 hours. The function will automatically
You can stop this function manually by touching the
button one more time.
This function increases both ice making and freezing
capabilities.
Water Filter Reset
When the water indicator turns on, you have to
change the water
press and hold the Accela Ice (Filter Reset) button for three
seconds to turn the indicator light
the water approximately every six months.
Light
Press the Light button to turn the light on and
dispensing water, a light underneath the water switch will
illuminate.
If the temperature in
After changing the water
You need to change
When