Table of Contents
Advertisement
10
Edit Welcome Message (a
maximum of 48 characters and 16
characters for each segment).
11
Door 1 Open interval (04-99
seconds). The relay will latch from
04-99 seconds.
12
Door 2 Open Interval (04-99
seconds). The relay will latch from
04-99 seconds.
14
Set Time (in military time).
15
Daylight Saving
16
Display Date
S
y
s
t
e
m
O
p
e
r
a
S
y
s
t
e
m
O
p
e
r
a
S
y
s
t
e
m
O
p
e
r
a
How to Initiate a Call.
How to answer the AeGIS calls.
How to extend the talk time.
How to use the voice mail feature.
AeGIS 8000 Series
Quick Installation Guide & Software Operation
t
i
o
n
s
t
i
o
n
s
t
i
o
n
s
Page 7
75
Enable or Disable Key-press Beep
(key will beep on initial call or
when the access code is used to
open the door.
76
Enable/Disable Speaker Beep when
the System Open the Gate/Door.
Enabled: the system will beep if the
door is opened.
Disabled: the system will not beep
if door is opened.
77
Enable or Disable PBX. Only used if
the system is connected to a PBX
line and the system must dial the
outside lines, otherwise do not
enable this function.
78
View Directory and Name.
Press "3" to view the next name
and # to view the directory
associated with the name.
79
Talk Time (10-180 seconds).
91
Exit (remote programming only).
Two ways to initiate call:
1.
Press "3" to view tenant's name from A to Z or
"6" to view from Z-A, when the tenant name
you are intending to call is visible on the
display, press # to initiate the call.
2.
Press # and wait for dial tone and press the
directory code.
If Multi systems are installed, the others will display
TEL LINE BUSY if one is used.
Answer the AeGIS calls and press the associate
number to open the door remotely or hang-up if you
do not want to open the door. The number to open
the door is the number programmed according to
the open door 1 and open door 2 number (function
code 20 and 21). Default setting is "9" to open door
1 and "8" to open door 2.
The Talk-Time can be programmed in the system
from 10 to 180 seconds. The system will give ONE
LONG BEEP ten seconds before the Talk-Time
expires. The tenant must press "#" immediately
after the long beep to extend the Talk-Time to
another cycle. If the Talk-Time is programmed for
30 seconds and it can be extended for another 30
seconds by pressing "#" from the tenant phone
after you hear the long beep. Tenant may continue
pressing the "#" every time you hear the warning
beep to extend the talk time until the conversation is
finished.
The AeGIS 8000 Series keypad will be activated
after the call is connected even though the function
Code 75 is disabled. The purpose of the keypad
activated is to allow the user to press an extension
number or a voice mail number after the call is
connected.
12/21/01
Advertisement
Table of Contents
