Table of Contents
Advertisement
How to Use the Personal Access Code.
How to call into the AeGIS system.
How to adjust the volume.
How to adjust the LCD display.
How to adjust the pulse sensitivity.
How to check the number of tenants on the
system.
Postal Switch.
T
r
o
u
b
l
e
S
h
o
o
T
r
o
u
b
l
e
S
h
o
o
T
r
o
u
b
l
e
S
h
o
o
No audio when key is pressed.
No dial tone when the # key is pressed.
AeGIS 8000 Series
Quick Installation Guide & Software Operation
t
i
n
g
G
u
i
d
e
t
i
n
g
G
u
i
d
e
t
i
n
g
G
u
i
d
e
SOLUTIONS and SUGESTIONS
AUDIO PROBLEMS
Page 8
Press ∗ then your 4-digit personal access code.
Dial the AeGIS phone number and ONE SHORT beep
will be heard. Press "∗" to talk to the visitor and
press the associated number as programmed on
function code 20 or 21 to open the door. This
feature does not work for multi systems on single
phone line.
The speaker volume and microphone are factory
preset. See figure 2 to locate the speaker volume
adjustment pot. Turn the speaker volume
adjustment pot counter-clockwise to increase or
clockwise to decrease the speaker volume. If you
hear "feedback" when you close the cabinet's door,
decrease the speaker volume.
Turn the LCD Adjustment Pot clockwise to increase
or counter-clockwise to decrease the intensity. See
figure 2 to locate the LCD adjustment pot.
Apply power to the system and connect the
§
phone line.
If the Pulse Sensitivity LED flashes or comes
§
ON, decrease the pulse sensitivity by turning
the Pot adjustment clockwise, otherwise
proceed to step 3.
If the Pulse Sensitivity LED does not flash or
§
comes ON, press the keypad number 0-9 and
the LED should be flashed every time the key
number is pressed. If it does not flash, increase
the sensitivity by turning the pot counter-
clockwise.
Press and hold "0" and press "#" and release both
keys. The "Welcome Screen" will stop scrolling and
then enter your valid 4-digits Master Code. Press "∗"
and the display will show the number of tenants.
The system has a built-in postal switch. You must
get the postal lock from the local post office. The
postal switch is Normally Open (NO). If Normally
Closed (NC) is used, remove the wire from NO to
NC. The postal switch can also be used for exit
button or card reader.
Check the speaker and microphone connection
§
on terminal marked CN4 on the board. The
snap on clip connector must be facing inside the
board.
Check the red and orange wires, make sure
§
they are soldered into the speaker.
Turn the system's power "OFF" and disconnect
§
the speaker connector from the board. The
speaker impedance must be 24 ohms.
Check the phone line using a standard phone,
§
make sure you get a dial tone.
Check the speaker and microphone connection
§
on terminal marked CN4 on the board.
12/21/01
Advertisement
Table of Contents
