Table Of Contents - LEGRAND adorne ADWR700MMTU User Manual

TABLE OF CONTENTS

Table of Contents
System Introduction
Configuring the System
Setting a House ID
Creating Groups
Setting up Remote Controls
Custom Settings
Expanding the System and Interfacing
with Other Programs
Operating the System
Designing a System
Product Overview
Specifications
Frequently Asked Questions
2-3
4-9
4
5-6
7-9
10-11
12-16
17-20
21
22-25
26-28
29-30
Safety Considerations
Lamp Replacement
It is a safety requirement that lighting loads be electrically isolated for relamping. To
do this, use the air-gap switch to the right of the adorne device as shown and move the
switch upwards. When the LED goes out, the load is safely isolated for relamping. To
restore normal operation, move the switch back to the down position.
Dimmer Derating
For multi-gang installations, use pliers to break off the specified heat sink fins.
De-rate the maximum load according to the following table.
Rated Load
Incandescent/Halogen 700W
MLV 700VA
EFL 5.5A
ELV 700W
Overload Protection
adorne Wireless Lighting dimmers and switches feature overload and short-circuit
protection. In the event of an overload condition, the device will stop working, and the
status LED will be rapidly flashing red at 2 Hz. Set the dimmer to off, disconnect loads
in excess of the dimmer's rating, and try again.
SAFETY CONSIDERATIONS
Airgap Switch
2-Gang Installation 3-Gang Installation
600W/600W 600W/500W/600W
600VA/600VA 600VA/500VA/600VA
5.5A/5.5A 5A/5A/5A
600W/600W 600W/500W/600W
Flashing Red
1