Advertisement
These four PIO fields let you set a PIO mode (0-4) for each of four IDE devices. When under "Auto" mode,
the system automatically set the best mode for each device
3.7.3 IDE Primary & Secondary Master/Slave UDMA
When set to "Auto" mode, the system will detect if the hard drive supports Ultra DMA mode.
3.7.4 On-Chip primary/Secondary PCI IDE
Select "Enabled" to activate each on-board IDE channel separately, Select "Disabled", if you install an add-
on IDE Control card
3.7.5 USB Keyboard Support
This item lets you enable or disable the USB keyboard driver within the onboard BIOS.
3.7.6 Init Display First
Select "AGP" or "PCI Slot" for system to detect first when boot-up.
3.7.7 Onboard FDC Controller
Select "Enabled" to activate the on-board FDC
Select "Disabled" to activate an add-on FDC
3.7.8 Onboard Serial Port 1 & 2
Select an address and corresponding interrupt for the first/second serial port. The default value for the
first serial port is "3F8/IRQ4" and the second serial port is "2F8/IRQ3".
3.7.9 UR1 & 2 Mode Select
Select to activate the Infrared transfer function.
3.7.10 Onboard Parallel Port
Select address and interrupt for the Parallel port.
3.7.11 Parallel Port Mode
Select an operating mode for the parallel port. Mode options are SPP, EPP1.7, EPP1.9, ECP and
ECPEPP1.7, ECPEPP1.9.
3.7.12 ECP Mode Use DMA
Select a DMA channel if parallel port is set as ECP1.7, ECP1.9, ECPEPP1.7 or ECPEPP1.9.
3.8 Load BIOS Defaults
This loads the standard BIOS default values. To select, highlight it and press the <Enter> key. Then
press the <Y> and <Enter> keys to confirm. Otherwise, press the <N> key to cancel.
3.9 Load Setup Defaults
This feature loads the setup default values from BIOS default table. To select, highlight it and press
the<Enter> key. Then press the <Y> and <Enter> keys to confirm. Otherwise, press the<N> key to
cancel.
3.10 Supervisor/User Password
You can assign, modify, or cancel password settings. To modify, highlight "Supervisor Password"
or "User Password" and press the <Enter> key. The screen will prompt you (Enter Password:). Enter
Advertisement
