Toro 139-1000 Installation Instructions Manual page 4

4
Assembling the Hoses to
the Fuel Cooler
Parts needed for this procedure:
1 Fuel cooler
2 Hose clamp
Bolt (1/4 x 5/8 inch)
1 Fuel cooler bracket
1 Hose (long)
1 Hose (short)
2 Foam (short)
2
Foam (long)
2 Push-in hose clamp
Procedure
1. Slide a push-in hose clamp onto the end of each
hose (Figure 4).
2. Slide a hose clamp onto the end of each hose
(Figure 4).
3. Connect the hose ends to the fuel cooler and
secure them with the hose clamps.
4. Fasten the fuel cooler to the fuel cooler bracket
with 4 bolts (1/4 x 5/8 inch) as shown in
5. Remove the backing from the foam pieces and
adhere them to the fuel cooler bracket
1. Long hose
2. Foam (short)
3. Foam (long)
4. Fuel cooler bracket
5. Fuel cooler
Figure 4.
(Figure 4).
4
Figure 4
6. Bolt (1/4 x 5/8 inch)
7. Hose clamp
8. Push-in hose clamp
9. Short hose
g287327