Advertisement
3
Removing the Existing
Bracket and Fuel Hose
No Parts Required
Procedure
1.
Remove the existing fuel hose shown in
2.
1. Existing fuel hose
Note:
The following steps are only for machines
that do not have existing holes in the radiator
support. Refer to
existing holes.
2.
Remove the radiator bracket on top of the
radiator
(Figure
3).
Figure 2
Figure 1
for locating the
Figure
1. Nuts
2. Radiator bracket
3.
Remove the 2 bolts on each side of the radiator
(Figure
4.
Remove the 3 bolts at the bottom of the radiator
on each side
5.
Raise the radiator up enough to slide out the
existing radiator support (without existing holes).
Refer to
6.
Slide the radiator support out towards the rear of
the machine.
7.
Raise the radiator up, slide the new radiator
support under the radiator, and secure it with the
g287536
bolts removed in
3
Figure 3
3. Bolt
3).
(Figure
3).
Figure 1
for finding existing holes.
Figure
3.
g287454
Advertisement
