Cleaning Solutions; Cleaning The Fingerprint Reader - Motion Computing LE1700 User Manual

Cleaning solutions

This section describes various cleaning solutions that have been tested by
Motion Computing. Please review the manufacturer's guidelines for proper use of the
product.
Product Type
Alcohol Prep Pads
Cavi-Wipes
Germicidal Wipes
(Super Sani-Cloth)
MOC Reviver
PVP-I Prep Pads
Sani-Cloth
Screen Cleaner
Vira-Guard
Virex

Cleaning the fingerprint reader

Under normal circumstances, you should clean the fingerprint reader once a month, or
whenever necessary.
To clean the fingerprint reader
1. Shut down the Tablet PC, unplug it, and remove the battery.
2. Lightly spray a cotton swab with household window cleaner.
3. Gently rub the sensor surface with the cotton swab, slowly rotating the swab so a new,
clean surface of the swab is constantly exposed to the sensor surface. Do not allow
cleaner to drip or run down into the electronics around the sensor.
Do not use bleach, solvents, or abrasives. Do not spray or pour any liquid directly on the
sensor.
4. After cleaning, gently rub the surfaces again with a clean, dry cotton swab. Use a clean
swab each time you clean the sensor.
56 Chapter 4
Manufacturer
Dynarex
Metrex
PDI
MOC
Triad
PDI
Office Depot
Veridien
Virex
Care and Maintenance
Comments
For general purpose use only. Not considered a
disinfectant for health care environments.
Can be difficult to clean off. Can leave a film on
the product.
Requires gloves for use and can be difficult to
clean off. Effective on acrylic displays but can be
difficult to clean off the ViewAnywhere display.
Can be difficult to clean off. Can leave a film on
the product.
Can leave a yellow film on the product.
Requires gloves for use and can be difficult to
clean off.
For general purpose use only. Not considered a
disinfectant for health care environments.
Highly recommended.
Can be difficult to clean off. Can leave a film on
the product.