Receiving A Crated Analyzer; Figure 3-1 Crated Analyzer - Siemens Maxum Edition II Installation Manual

Installation Steps

3.3 Receiving a Crated Analyzer

3.3 Receiving a Crated Analyzer
Figure 3-1
When the Maxum II is shipped to the installation site in a reinforced crate with vibration
protection, it will be clearly labeled for horizontal placement and handling.
● On receipt of the unit, look for any visible damage and verify that all items noted to be
shipped were received. Record on the receipt any damage or missing items noting the
item(s) and quantity missing on all copies. If anything is damaged or missing, then also
notify your Siemens representative or authorized agent of the damage to the equipment.
Protect from weather
If the unit is to be stored, it should be protected from the weather (the crate does not provide
weather protection.) If left outside in the weather, severe damage to the unit may occur. If the
unit is to be shipped to another location, preserve the vibration isolation provided in the original
shipping crate, or address the vibration isolation in the shipment method.
Note
Use proper lifting methods and equipment
A crated Maxum II will weigh a minimum of 200 pounds (90 kg), and can weigh substantially
more depending upon the configuration. Use a forklift or other suitable load-handling
equipment until it is uncrated.
● Place the crate on the floor horizontally with the orientation label THIS SIDE UP pointed up.
● Remove the metal bands from around the crate.
● Unscrew the cover and remove the crate cover. Remove the crate sides to facilitate removal
of the unit. Remove the wooden 2x4 supports and foam blocks from the top of the analyzer.
The analyzer will be covered in a plastic sheet.
● The Maxum II is bolted to a plywood sheet that 'floats' on a foam shock-absorbing pad. The
plywood can optionally be left on the analyzer to aid in handling during mounting.
14
Crated analyzer
CAUTION
Installation Manual
Installation Manual, 12/2019, 2000595 Rev 1