Quest Engineering M35 Owner's Manual page 6

Hide thumbs Also See for M35:

Table of Contents

M35 / M65

1. Input Channel Volume – These three knobs determine the level of the sound sources connected to the

inputs.

2. Tone Control – These two knobs adjust the overall frequency response of the system. They allow up to 10dB

of cut/boost on the 100Hz and 10kHz bands.

3. Master Volume Control – This knob determines the overall volume of the system.

4. Indicators (3) – The "Protect" indicator lights when the protection circuit is activated. The outputs are then

deactivated. The "Signal, -20dB and Clip" LEDs indicate the output level. The "Power" indicator lights up

when the device is powered on and ready for use.

5. POWER switch - This switch turns the device on/off. The POWER indicator lights up when the power is on.

6. AUX input

[Figure 1.1 Front panel diagram]

M-Series – Front Panel Presentation

Table of Contents

M65