Nedis SPBT1000 - Bluetooth Speaker Manual

Table of Contents

Overview

1.	On/off button	Press and hold the button for 5 seconds to switch on or off the device. SD card/Bluetooth mode: Press the button to play or pause the track. Press and hold the button to select the mode. Bluetooth mode: Double-press the button to disconnect Bluetooth. Hands-free mode: Press the button to answer or end the call. Press and hold the button to switch between phone and speaker. Double-press the button to reject the call.
2.	Volume + button Next button	Press and hold the button to increase the volume. SD card/Bluetooth mode: Press the button to select the next track.
3.	Volume - button Previous button	Press and hold the button to decrease the volume. SD card/Bluetooth mode: Press the button to select the previous track.
4.	Memory card slot (SD)	Insert the SD card (max. 32GB) with MP3 music files. The device automatically starts to play the MP3 music files.
5.	USB port	To charge the device, connect the USB cable to the USB port of the device and to an USB adapter or computer. The red charging indicator comes on. The device starts charging. When the charging process is completed, the red charging indicator goes off.

Pairing the speaker

Pairing the speaker with TWS function
The True Wireless Stereo (TWS) function only works when you have two speakers.

Follow the steps under the section "Pairing the speaker".
The device automatically assigns the left channel (host device) and the right channel (vice device).
Next time the speakers are switched on, the two devices will be paired automatically.
To stop the TWS function, double-press one of the on/off buttons.

General safety

Read the manual carefully before use. Keep the manual for future reference.
The manufacturer is not liable for consequential damages or for damages to property or persons caused by nonobservance of the safety instructions and improper use of the device.
Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
The device is suitable for indoor use only. Do not use the device outdoors.
The device is suitable for domestic use only. Do not use the device for commercial purposes.
Do not use the device in locations with high humidity, such as bathrooms and swimming pools.
Do not use the device near bathtubs, showers, basins or other vessels containing water.
Do not use a timer or a separate remote-control system that switches on the device automatically.
Do not cover the device.
Place the device on a stable, flat surface.
Keep the device away from flammable objects.

Electrical safety

To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
Disconnect the product from the mains and other equipment if a problem should occur.
Do not use the device if the mains cable or mains plug is damaged or defective. If the mains cable or mains plug is damaged or defective, it must be replaced by the manufacturer or an authorised repair agent.
Before use, always check that the mains voltage is the same as the voltage on the rating plate of the device.
Do not move the device by pulling the mains cable. Make sure that the mains cable cannot become entangled.
Do not immerse the device, the mains cable or the mains plug in water or other liquids.
Do not leave the device unattended while the mains plug is connected to the mains supply.
Do not use an extension cable.

Cleaning and maintenance

Before cleaning or maintenance, always switch off the device, remove the mains plug from the wall socket and wait until the device has cooled down.
Do not use cleaning solvents or abrasives.
Do not clean the inside of the device.
Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
Do not immerse the device in water or other liquids.
Clean the outside of the device using a soft, damp cloth. Thoroughly dry the device with a clean, dry cloth.
Clean the ventilation openings using a soft brush.