The Status Indicator; Setting Up And Using Tv Inputs - Mitsubishi Electric WD-65738 Basic Owner's Manual

The STATUS Indicator

Key Off
Slow Blinking
LED Color TV Condition
TV is powered off. Normal operation.
None
TV is powered on. Normal operation.
Green
TV powered off, auto-on TV Timer is
Green
set.
Normal operation. TV can be turned on
at any time.
TV just powered off and lamp is
Green
cooling.
Sixty seconds after turning off TV, LED
will start to blink. TV can be turned back
on before blinking starts or after blink-
ing stops, but not while the indicator is
blinking. Normal operation.
TV is too hot. The TV will display a
Yellow
warning message and shut off if it over-
heats.
• Ambient room temperature may be
too high. Turn off the TV and let the
room temperature drop.
• Clear blocked air vents. Ensure at
least a four-inch clearance on all
sides of the TV.
Lamp access door is not secure or no
Yellow
lamp installed.
TV will not operate until lamp access
door is secured. See Appendix A.
Lamp failure. Replace the lamp. See
Red
Appendix A.
TV may require service.
Red/
• Hold power button on front panel for
Yellow
10 seconds to reset TV.
• If LED continues to flash red and
yellow after reset, turn off the TV and
unplug it from the AC power source.
Wait one minute and then plug the
set back in.
• If LED continues to flash red and
yellow, go to www.mitsubishi-tv.com
or call 1-800-332-2119 to receive
Authorized Service Center informa-
tion.
You may be asked to count how
many times the LED flashes each
color to aid in troubleshooting.
1. Basic Setup and Operation
Steady On
Fast Blinking

Setting Up and Using TV Inputs

Using the ANT (Antenna) Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV's
ANT input. Refer to page 12.
You must perform a channel scan to enable recep-
tion of digital channels. If you skip this step, the TV
will receive only analog channels. The channel scan
will search for high-definition and standard-definition
channels available in the local area.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
1.
Power on the TV.
2.
Press MENU and open the Setup > Channel menu.
First press to navigate to the Setup icon, then
use to highlight the Channel icon.
Start channel memorization from the Setup > Channel
menu.
3.
Press to enter the menu.
4.
Highlight Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cable for service over direct cable
(no cable box). Press ENTER to add a
check.
5.
For first-time setup, highlight
channels. To scan for channels not
already in memory, highlight New
only. Press ENTER to add a check.
6.
Highlight Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press CANCEL.
For assistance call 1(800) 332-2119
7
All