Install The Remote Control Battery - SYMA S107H-E User Manual

Important: battery charging information
1. Rechargeable batteries should be removed from the toy before being charged.
2. Rechargeable batteries should only be charged under the supervision of adults.
3. Exhausted batteries should be removed from the helicopter.
4. Caution: Risk of explosion if battery is replaced with incorrect ones. Please dispose the batteries
according to the instructions.
5. Don't use or leave the battery near a heat source such as fire or heater.
6. After flying, don't charge batteries at once to avoid batteries too heat to cause to the fire, make sure
it cool down before charging.
7. Don't hit or let batteries fall down when charging to avoid inner short-circuit.
8. Only use the supplied adapter for charging. If the battery is aging, please replace it with a new
battery in time.
9. After fully charged, please remove the adapter in time, otherwise the battery will be discharged and
charged again, which will shorten the battery life.
10. The toy is only to be connected to Class II equipment bearing the symbol:

3.3 Install the remote control battery

Transmitter battery installation: open the battery cover at the back of the transmitter. Install 4pcs AA
batteries according to the polarity indications (Note: batteries are not included).
Note:
!
1. During the battery installation, it must be ensured that the polarities of the batteries are matched
with that of the battery box. No battery shall be installed with the opposite polarity.
2. Please do not use new and old batteries together.
3. Please do not use different types of batteries together.
4. Do not use rechargeable batteries.
7
Battery Cover
4 x AA Batteries