Denon AVC-X4800H Owner's Manual page 246

Contents Connections
o HDMI Audio (ZONE2 only)
Selects the audio signal format for playing an HDMI source in ZONE2.
Through
(Default):
PCM:
z When the same input source is set for both MAIN ZONE and ZONE2, PCM 2-
channel is used for the audio in MAIN ZONE too. However, it may not be
possible to convert the signal from some playback devices to a PCM signal
using this setting.
o Volume Level
Set the volume output level.
Variable
(Default):
1 – 98
(–79 dB – 18 dB):
0 The dB value is displayed when the "Scale" setting is " –79.5 dB – 18.0 dB".
(v p. 172)
Front panel Display
Playback
The HDMI audio signal is passed through
this unit to the device in ZONE2.
The HDMI audio signal input into this unit
is converted to a PCM signal that can be
output from the ZONE2 PRE OUT
connectors or speaker terminals.
Volume can be adjusted.
Volume is fixed at the desired level. The
volume cannot be adjusting using the
remote control unit.
Rear panel
Settings
o Volume Limit
Make a setting for maximum volume.
60 – 80 (–20 dB – 0 dB)
(Default : 70 (-10 dB))
Off:
z
0 This can be set when "Volume Level" is set to "Variable". (v p. 246)
0 The dB value is displayed when the "Scale" setting is " –79.5 dB – 18.0 dB".
(v p. 172)
o Power On Volume
Sets the initial volume level when the power is turned on.
Last
(Default):
Mute:
1 – 98
(–79 dB – 18 dB):
0 This can be set when "Volume Level" is set to "Variable". (v p. 246)
0 The dB value is displayed when the "Scale" setting is " –79.5 dB – 18.0 dB".
(v p. 172)
246
Remote
Tips Appendix
Do not set a maximum volume.
Sets the power-on level to the last-used
volume level.
Sets the power-on level to mute level.
Sets a specific power-on level.
Index