Yeti SB120 Owner's Manual page 9

07
Lightly grease and place 2x Race Extenders
(3.5) onto the lower bearings in Link Assembly
(3.14). Install into front triangle using Link Pivot
Collet Axle (3.4) and plain Collet Nut (3.2). Apply
Loctite to the threads and grease the shaft of
the Pivot Collet Axle (3.4). Apply grease to Link
pivot cavities.
Torque: 25 Nm
10
Lightly grease and place 2x Race Extenders (3.5) onto the upper bearings in Link Assembly (3.14). Rotate
rear triangle and Link together, lining up SS Pivot bores.
Apply Loctite to the threads and grease shaft and underneath the head of the SS Pivot Screws (3.3).
Install 2x SS Pivot Screws (3.3) from the inside of the Link and partially into the rear triangle.
Apply grease to SS pivot cavities and place 2x plain Collet Nut (3.2) into the rear triangle.
Using a wrench from the outside of the swingarm, begin tightening in the "left-hand" direction (this is
still a standard thread, but installed from the inside), tightening the SS Pivot Screw and Collet Nut.
Torque: 25 Nm
08
Assemble Shock Extender Assembly (3.15) to SB120 Link (3.14) by placing 2X Race Extender (3.13) in the
extender cavities and sliding between the link tabs. The threaded extender tab should face upwards,
thru hole tab facing downward. Secure with a Guide Pin and assemble Female 8x41mm Bolt (3.17) with
Washer (3.21) through the assembly. Apply Loctite to the threads and secure with Male M6 Bolt (3.19)
and Washer (3.20).
Torque: 10 Nm
11
Grease wedge and threads. Install Large
Collet Wedge Bolts (3.9) into 2x Collet Axles
(3.1) and (3.4)
Torque: 14 Nm
SB120 | OWNER'S MANUAL
09
Apply grease to main pivot cavities of rear
triangle. Slide rear triangle assembly onto
main pivot and secure with Main Pivot Collet
Axle (3.1) and Routing Collet Nut (3.7),
placing routing feature at the top. Apply
Loctite to the threads and grease shaft of
the Pivot Collet Axle (3.1)
Torque: 25 Nm
Install a plain collet nut (3.2, flat top with no
clamp feature) if kit uses a wireless drivetrain.
QC CHECK
Cycle rear triangle through to make sure motion
is smooth.
Take precaution to make sure link does not
contact seat tube.
9