Remove The Blade; Install The Shoe; Remove The Shoe; Operation - GreenWorks RS24L411 Operator's Manual

EN
2. At the same time, push the blade to the deepest position.
3. Release the blade release clamp.
Make sure that the blade is tightened. When cutting wet
wood, please clean up the dust and debris near the blade
clamp in time.
6.5

REMOVE THE BLADE

1. Lift the blade release clamp and hold.
2. At the same time, pull the blade out.
3. Release the blade release clamp.
6.6

INSTALL THE SHOE

1. Turn the shoe release lever counterclockwise.
2. Push the shoe into the machine.
3. Turn the shoe release lever to original position.
Make sure that the shoe is tightened.
6.7

REMOVE THE SHOE

1. Turn the shoe release lever counterclockwise.
2. Pull the shoe from the machine.
3. Turn the shoe release lever to original position.
7

OPERATION

Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
NOTE
NOTE
WARNING
WARNING
English
7.1

START THE MACHINE

1. Push the lock-out button to the left side to unlock the
switch trigger.
2. Pull the switch trigger.
Before you use the machine, wait until the blade gets to
fully speed.
7.2

STOP THE MACHINE

1. Release the switch trigger.
7.3

OPERATE THE MACHINE

1. Clamp the work piece.
2. Rest the front shoe of the saw on the work piece.
3. Start the saw on the work piece.
Make sure that the blade is not contacting the work piece.
Flush cutting
1. The compact design of the machine permits close cutting
to floors, corners and other difficult areas.
8
WARNING
NOTE