Remove The Blade; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks CRG404 Operator's Manual

10.3

REMOVE THE BLADE

1. Push the spindle lock button to lock the spindle.
2. Use the hex key to loosen the blade bolt
counterclockwise.
3. Remove the bolt and outer flange.
4. Use the lower guard lever to lift the lower guard
and hold the lever.
5. Remove the blade.
10.4

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1. Align the ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery
compartment until the battery pack locks into
place.
3. When you hear a click, the battery pack is
installed.
10.5

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
English
1
3
4
2
11

OPERATION

Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
11.1

START THE MACHINE

The machine can not work until the lock-off button is
pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Pull the trigger to turn the machine ON.
11.2

STOP THE MACHINE

1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come
to a complete stop.
11.3

CUTTING ANGLE

6
1. Loosen the bevel lock knob (6).
2. Use bevel scale to set the necessary angle.
3. Tighten the bevel lock knob.
9
WARNING
WARNING
1
2
NOTE
WARNING
EN