Daikin FHA50AVEB98 User Reference Manual page 54

16 | Unit installation
To open the indoor unit
To mount the indoor unit
Installer and user reference guide
54
NOTICE
Do NOT install the unit tilted in other ways than specified. Possible consequence: If
the unit is tilted against the direction of the condensate flow (the drain piping side is
raised), the float switch might malfunction and cause water to drip.
▪ Remove the suction grille. Slide the fixing knobs to the back (2 for class 35+50, 3
for class 60~140), open the suction grille wide and hold the rear knob. Pull the
suction grille to the front to remove it.
a
a Fixing knob
b Suction grille
a
a Rear knob
▪ Remove the decoration side covers (right, left). Remove the fixing screw from
both side covers, pull the decoration panel to the front and remove the
accessories.
a
b
c
a Accessories
b Fixing screw for side covers
c Decoration side cover
1 Open the knockout hole at the wiring inlet at the rear or the top of the unit,
and install the resin bushing (accessory).
a Resin bushing (accessory)
b Knockout hole (for leading in from the top)
c Knockout hole (for leading in from the rear)
b
a
b
c
a
FHA-A(9)
Split system air conditioner
4P708119-1 – 2022.11