Table of Contents
Advertisement
2 - GENERAL DESCRIPTION OF THE VEGA MK II PANEL
2.5 Functioning warning lights
Cool
It indicates that the conditioning system is in Cool Mode.
If the Vega MK II panel is connected to a Fan Coil unit, the COOL warning light blinks
when the Cool Mode is on but the circulation water temperature is too warm.
Heat
It indicates that the conditioning system is in Heat Mode.
If the Vega MK II panel is connected to a Fan Coil unit, the HEAT warning light blinks
when the Heat Mode is on but the circulation water temperature is too cool.
Auto
It indicates that the fan control is in Automatic Mode.
In this case the Vega MK II panel controls the fan speed, increasing or decreasing it
automatically to reach and keep the set out temperature (Set Point). When the AUTO
warning light is not blinking, the fan is in Manual Mode, so its speed is chosen by the
user and it will not change automatically.
Fan speed
The four warning lights indicate the fan speed: from minimum on the left to the extra-
maximum on the right.
2.6 Probes
In the Vega MK II panel there are two probes:
Infrared probe, at the top in the center, to communicate with the radio-control device.
Temperature internal probe at the bottom under the buttons area.
Pag.
4
Advertisement
Table of Contents
