Table of Contents
Advertisement
1.1 Electrical connection
It's very easy to connect Vega MK II to the powerboard using an eight
poles cable (straight) and a RJ45 connector. The standard length of this
cable is four meters.
1.2 Power On
Power On means that the panel is supplied. In Power On the following information is
given: [r x.x].
1.3 Software relay
The indication looks like the following: [rx.x].
1.4 Program from the powerboard
Vega MK II panel connected to a FAN COIL UNIT
The Vega MK II panel connected to a Fan Coil unit. It is a digital panel that can set
up both Fan Coil units and Compact and Split units, because it recognizes automati-
cally the system to which it is connected.
You can identify the unit model thanks to the dip switch on the unit powerboard ( for
Compact and Split units the model and for Fan Coil units the configuration).
If the Vega MK II panel is connected to a Fan Coil unit, there are four programs types
that can be downloaded (with water valve, Fan Only, with strip heater).
Vega MK II panel connected to a COMPACT or SPLIT UNIT
The powerboard of the Compact or the Split unit is already set out for the model
(EH, CO, RC). Only for replacement powerboards the setting out is neutral (dip
switch OFF-OFF).
1 - INSTALLATION
Pag.
1
Advertisement
Table of Contents
