→
→
P2
P2
P2(a)
P2(a)
* Both (a) and (b) are programmed in, this action only remotes remote (b).
Deleting ALL Saved Remotes
→
→
P2
P2
STOP
Deleting All Limits
→
→
P2
P2
DOWN
Adding a Wind/Sun Sensor
→
→
P2
P2
P2(a)
P2(a)
(wind-sun sensor)
Enable/Disable Sun Detection
1. Enable Sun Detection
+
UP
STOP
Press the UP and STOP buttons simultaneously (3 beeps
& 3 jogs). Sun detection is enabled.
Error
Motor has no response
Press P2
P2
jog), on the remote to delete, press P2 again (3 beeps and 1
jog). The remote has been deleted.
P2(b)
Press P2
P2
press P2 again (3 beeps and 1 jog). All remotes have been
deleted.
P2
Press P2
P2
press P2 again (3 beeps and 1 jog). All limits have been
deleted.
P2
Using a paired remote, press P2 twice (motor
M
A
UP
P2
per press), then press P2 on the wind/sun sensor (3 beeps and
1 jog). The wind/sun sensor is now paired with the motor.
P2
Troubleshooting
1.
Power failure or incorrect connection
2.
Remote battery empty.
3.
Remote interference.
4.
Remote out of range.
(1 beep and 1 jog), press P2 again (1 beep and 1
(1 beep and 1 jog), press STOP (1 beep and 1 jog),
(1 beep and 1 jog), press DOWN (1 beep and 1 jog),
2. Disable Sun Detection
+
DOWN
STOP
Press the DOWN and STOP buttons simultaneously
(long beep & 1 jog). Sun detection is disabled.
Possible cause
15
1 beep and 1 jog
Possible solutions
1.
Double check power and wiring connec-
tions.
2.
Replace battery.
3.
Check that antenna on motor is intact
and exposed. Check for possible radio
interference.
4.
Try remote in closer range to motor.