Before The Installation - Schartec Tube FE Installation And Operating Instructions Manual

Roller shutter motor with electronic limit setting

Table of Contents

Available languages

Requirements

The warranty claim is only valid for the country in which the device was purchased. The goods must have been purchased through the sales channel

specified by us. The warranty claim is only valid for damage to the subject matter of the contract itself. Reimbursement of expenses for removal and

installation, inspection of corresponding parts, as well as claims for lost profit and damages are excluded from the warranty. The proof of purchase is

valid as evidence for your warranty claim.

Performance

For the duration of the warranty, we will remedy all defects in the product that are demonstrably due to a material or manufacturing defect. or man-

ufacturing defect. We undertake, at our discretion, to replace the defective goods free of charge goods free of charge against defect-free, repair or

replace a reduced value. Excluded are damages due to:

• Improper installation and connection

• Improper commissioning and operation

• External influences such as fire, water, abnormal environmental conditions

• Mechanical damage due to accident, fall or impact

• Negligent or wilful destruction

• Normal wear and tear or lack of maintenance

• Repair by unqualified persons

• Use of parts of foreign origin

• Removal or obscuring of the serial number

• Replaced parts become property of the manufacturer

Read these instructions carefully before installation.

Make sure that the roller shutter is free from damage and can be opened and closed smoothly. If necessary, replace damaged components.

Check the installation position of the motor in the shutter box by lowering the shutter completely and see if the motor should be installed on the

left or right side of the shutter box. Always choose the shortest path to the nearest junction box, as electrical wiring must not be routed inside the

shutter box.

Always make sure that the motor can be pushed completely into the shaft as far as it will go.

ACHTUNG

Important! Read safety instructions before installation! Never drop, hammer, drill, or submerge the motor. Keep the power cable in the right position as

seen below. Incorrect installation can lead to serious injury and will void the manufacturer's liability and warranty.

Motor Installation

Step 1: Cut drive tube to required length.