Adjusting The White Balance - Minox DD200 Instruction Manual

3. Using the /T button (up) and /W button (down) you
can move around in the menu selection. Select the Setup
function "Quality" and confirm with the OK/Menu button.
4. Select the desired quality
*** high = without compression
** normal = low compression
* low = high compression
4M interpolated
If you are using the internal memory the following
imaging capacities are available:
*** without compression,
17 photos with a resolution of 2048 x 1536 pixels
** low compression,
27 Photos with a resolution of 2048 x 1536 pixels
* high compression,
36 Photos with a resolution of 2048 x 1536 pixels
4M interpolated,
17 Photos with a resolution of 2304 x 1728 pixels
5. Confirm the desired quality/compression by pressing the
OK/Menu button. A beep signal confirms the change.
6. If you wish to change the quality/compression rate per-
manently, confirm your change in the setup mode under
"Setting".
12

Adjusting the white balance

Your camera automatically sets the white balance to suit
the ambient light of the subject matter in your picture. In
difficult light conditions or to achieve special effects you
can also set the white balance manually. For this purpose
always observe the following instructions:
1. Switch the DD200 on by pressing the Power On/Off button.
You are now in shooting mode.
2. Press the OK/Menu button to access the main menu.
3. Using the /T button (up) and the
you can move around in the menu selection. Select the
function "WB" and confirm with the "OK/Menu button".
4. Select the desired white balance
- Auto
- Day light
- Cloudy
- Lamp
- Tungsten
- Night
5. Confirm the desired white balance by pressing the "OK/
Menu button". A beep signal verifies the change.
6. If you wish to change the white balance permanently
you must confirm your change in the setup mode under
"Setting".
/W button (down)