Network Port Configuration
Chapter 8
NETWORK PORT
Access the network options by selecting N
C
ONFIGURATION
network port is always used in frame relay protocol configurations.
The network port terminates the user end of the frame relay UNI
interface. The Express 5200 supports three standard PVC signaling
formats: LMI (gang of four), ANSI T1.617-D (Annex D), and ITU
Q.933-A (Annex A). The selected signaling format is used to poll
the network end of the UNI interface and retrieve virtual circuit
information. Optionally the polling process can be disabled.
User data is encapsulated into standard frame relay formatted
frames using two methods. FRF 3.1 IA procedures are used for IP
and LLC2 protocols, while a proprietary method is used for
transparent protocol mode. Virtual circuit sharing is allowed for
both methods.
Configure the
affect the choices available for the
61202175L1-1
menu. See the menu tree in Figure 8-1. The
before the
Network Port
DTE Ports
Express 5200 User Manual
P
from the
ETWORK
ORT
. Selections made will
DTE Ports
.
8-1