Chapter 13. Testing
3 TEST
Ping
Select 1 PING to send a ping request to a specific address. See
Figure 13-3 for the VT 100 P
Address to Ping (PING ADDRESS)
Enter the IP address of the unit the Express 5200 is sending an echo
request (ping) to.
If the IP address is not manually configured into the IP route table, the
path will be determined dynamically through RIP and inverse ARP pro-
tocols (for more information, see the chapter IP Routing on page 10-1).
Start Ping
Results are shown after the ping test has been performed. The
S
TART
requests to the target station. At the end of the ten-ping test, the
following results are shown:
Pings Transmitted (PINGS TX)
This field shows the number of pings sent (always 10).
Ping Responses (PINGS RX)
This field shows the number of responses received from the pinged
device.
13-2
1 PING
2 VOICE
1 LINE 1
2 LINE 2
Figure 13-2. Front Panel Test Menu
ING
P
command causes the Express 5200 to send ten ping
ING
Express 5200 User Manual
1 PING ADDRESS
1 PINGS SENT
2 RESPONSES
3 MIN TIME
2 START PING
4 MAX TIME
5 AVG TIME
1 RING TEST (FXS only)
2 LOOPBACK
ENABLED
3 TEST TONE
DISABLED
M
.
ENU
61202175L1-1