Advertisement
Installing Recycler Decal
1.
Remove backing paper and apply decal to left
side of mower (Fig. 4). Smooth from center to
edges to remove air bubbles.
Figure 3
1. Mower left side
Assemble the Recycler
Baffles
1.
Place (4) 5/16"–18 x 1 1/4 bolts into the deep
recessed holes in the left and right baffles.
Secure the bolts with (4) 5/16" locknuts in the
shallow recesses. Refer to Figures 4 and 5 for
correct assembly and hole usage.
3
Figure 4
1. Deep recess
2. Bolt 5/16–18 x 1-1/4"
(31.8mm)
2
1
2036
2. Decal
2
1
2033
3. Locknut 5/16" (7.9mm)
Installing the Recycler Baffles
1.
Place the left side baffle inside the cutting
chamber. Secure it with (2) 5/16" locknuts and
(2) Bellville washers (Fig. 5).
Note:
Concave side of Bellville washers goes
toward the mower
2.
Place the right side baffle inside the cutting
chamber so the extended lug interlocks with the
left side baffle, and secure it with (2) locknuts
and 2 Bellville washers (Fig. 5).
2
5
4
5
Figure 5
1. Baffle left side
2. Baffle right side
3. Bolt 5/16–18 x 1-1/4"
(31.8mm)
3.
Tighten all mounting hardware securely.
4.
Rotate blades to assure there is at least 1/8"
clearance between blades and baffle.
5.
Install mower onto tractor; refer to Installing the
Mower, in Mower Operator's Manual.
Installation
3
3
4
4. Bellville washer
5. Locknut 5/16" (7.9mm)
1
5
2031
4
5
3
Advertisement
