Table of Contents
Advertisement
AP mode connection steps
Set device in pairing mode
When the device is first turned on, it may automatically enter pairing mode (status light is
flashing).
If not automatically in pairing mode when powered on, you can manually set the device in
pairing mode by using the pin and pressing and holding the reset button for 5–10 seconds.
The camera will emit a tone, then wait until the camera emits a different second tone. The
status light will then be flashing.
Using AP Mode to add device
1. Once registered, tap "+" in the upper right corner of the app's home page to add a
new device through the network.
2. Select the product type from the list of options in the app (Home Security > Cameras),
and then select "QR Code" from the top-right corner when asked to reset the device.
11
Advertisement
Table of Contents
