Table of Contents
Advertisement
IP Configuration
3
After you have connected the FortiExtender network interfaces, the device automatically
attempts to obtain an IP address from a DHCP server. If you do not use DHCP, you can
configure a static IP address.
To configure a static IP address:
1. Use an Ethernet cable to connect one of the LAN ports to the Ethernet port of your
computer.
2. Set the computer Ethernet port to DHCP mode, and connect it to port1, port2, or port3.
3. Open your web browser and point to the default FortiExtender web GUI address:
http://192.168.200.99
4. In both the username and password fields, type
your keyboard. (Note: If you are logging in to the device for the first time, you will be
prompted to change the default password. We strongly recommend that you change the
password right away.)
5. Go to Networking>Interface, where you'll see all the system interfaces.
6. Select a desired interface, set it to "static" mode, configure the static IP address, and click
Save.
14
admin
and press the Enter key on
Installation
4
The FortiExtender device is designed for placement near a window (desk or wall mount) to
achieve the best LTE signal strength. Refer to the diagram below for proper placement and
mounting.
Place on top of a desk or flat surface
1. Attach the rubber feet to the four corners on the bottom of the unit.
2. Place the unit on the desk or flat surface.
3. Attach the antennas.
15
Advertisement
Table of Contents
