Gio Electric Tron Owner's Manual page 15

Charging your Scooter
Your scooter does not come fully charged and requires a full charge before
your first use. To maintain the batteries life charge after use and don't allow
the battery to empty completely. Locate the charging port just below the
front of the seat, insert the corresponding end of your charger and then plug
into a standard wall socket. The light on the charger will illuminate
your scooter is charging and will switch to
(Approximately 8-10 hours)
Please note that your charger may become warm or emit sound during
charging, this is normal. Oppositely if it doesn't, this does not indicate a
problem with your charger.
Avoid dropping your charger and keep away from moisture & cold
temperatures! Your scooter will only charge and operate with the
breaker in the ON position!
Adjusting your scooter
The "smart" seat on the Tron has several possible adjustments.
Headrest
To adjust the height of the headrest, press the quick adjust button and shift
the headrest to the desired position. Release the button and ensure the
headrest is properly locked into place. Once at the desired height the angle
of the headrest cushion can be adjusted manually by turning it. The head
rest also shifts in unison with the backrest to offer the riders head support
when the backrest is lowered into a reclining position
The backrest of the scooter consists of 2 separate cushions sections and
vertical support. Each section automatically shifts with the pressure applied
by the rider. To recline simply lean back on the seat and allow the backrest
to adjust to your angle.
green when charging is complete.
red while
14