Connecting The Pc - tams elektronik ZEUS s88-BiDiB-Link Manual

tams elektronik

4.3. Connecting the PC

Connect ZEUS via the USB cable included in the package to you PC. In case the USB interface
has not been installed on your PC, you will receive an appropriate indication. You have to
download the driver from the internet then.
Settings in the software for HSI mode
When transferring data from the interface to the PC in HSI-88-mode, you have to make the
following settings in your software:

data transfer according to the HSI-88-protocol for serial interfaces,

number of s88 modules connected to the three bus lines. Hint: Observe the numbers of the
bus lines (see figure in section 4).
Settings in the software for BiDiB
BiDiB has been designed that way connected BiDiB-knots log in themselves at the software.
S88 modules are administered by the interface as BiDiB-knots when data transfer to the PC is
effected via the BiDiB-protocol.
ZEUS | s88-BiDiB-Link
Connecting ZEUS | 11