Fimco SK-110-8R Owner's Manual

(110 Gallon Skid Sprayer w/205cc B&S Engine, 8-Roller Pump & Deluxe Handgun)
Technical Specifications

110 Gallon Polyethylene Tank

205cc B&S Engine, 8.0 Gross Torque w/6:1 Gear
Reduction

8 Roller Pump - 10 GPM @ 250 PSI

Pressure Relief Valve

Deluxe Pistol Grip Handgun W/25' of Hose

Optional Trailers & Boom Features Available
Caution: When fully filled with water, this
sprayer will weigh approx. 1,150 lbs..
Consult the owner's manual for your vehicle
to verify that you are within it's load carrying
capacity.
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-800-831-0027
MONDAY-FRIDAY, 8:00 AM TO 5:00 PM CST
If you should have a question or experience a problem with
your Fimco Industries Product: Visit our website @
www.fimcoindustries.com or call the Toll free number above. Our
technical support representatives will be happy to help you.
In most cases a customer service rep. can resolve
the problem over the phone.
To obtain prompt, efficient service, always remember to give the
following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your
skid sprayer.
Retain a copy of your receipt for your unit, as it will be required
to validate any warranty service.
Warranted against manufacturer or workmanship defects from
date of purchase with copy of receipt:
Homeowner Usage: One Year
Commercial Usage: 90 Days.
OWNER'S MANUAL
Model: SK-110-8R (5301052)
Information About the Sprayer
Roller pumps are positive displacement pumps, which means
that the entire solution being pumped must go somewhere or
the pump will break. In this roller pumping system, solution is
drawn from the tank and forced to a planned source, such a
handgun. The pressure is controlled by a pressure relief valve,
which is a spring-loaded device that controls the amount of
fluid bypassed (recirculated) to the tank. The gray adjusting
cap is to be tightened to increase pressure and loosened to
decrease pressure.
Assembly Instructions
The sprayer is completely assembled. The only other time any
assembly is required is if you have purchased the optional
trailer assembly or optional boom assembly. It is ready to
operate after mounting it securely on a truck bed or mounting
an optional trailer kit.
NOTE:
Add proper oil to the engine crankcase and gasoline to the
gas tank. Always check the oil in the gear box. Remove the
plug on the side, oil should be visible. Add oil through the top
plug. Refer to the engine manual for the correct type and
amount.
It is important to test the sprayer with plain water before actual
spraying is attempted. This will enable you to check the spray-
er for leaks in the plumbing system.
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5004502 (11/20)]
Page 1