Stopping The Engine; Table 16: Post-Lubrication Time - ABB Turbo Systems Switzerland Power2 550-M44 Operation Manual

Operation Manual / Power2 550-M / High-pressure stage
6 Operation and service / 6.4 Stopping the engine
6.4

Stopping the engine

CAUTION
Residual heat in the low-pressure and high-pressure stage
If the residual heat in the low-pressure and high-pressure stage is not suffi-
ciently dissipated by the circulating lubricating oil, machine damage could
occur.
Observe the post-lubrication times and the oil pressure specified for
u
post-lubrication (see chapter Monitoring during operation / Lubricating
oil pressure).
Post-lubrication
Post-lubrication is required.
Observe the oil pressure specified for post-lubrication.
u
Table 16: Post-lubrication time
© Copyright 2022 ABB. All rights reserved.
Post-lubrication time [min]
20
HZTL4058_EN
Lubricating oil pressure →45
Rev.F March 2022