Miele CS1011 Operating And Installation Instructions page 5

Technical safety
~
Installation, repair and maintenance
work should be performed by a Miele
authorized service technician. Work by
unqualified persons could be
dangerous and may void the warranty.
~
Before installing the combiset,
check for externally visible damage.
Do not operate a damaged appliance.
A damaged gas combiset is a hazard.
~
Before installation, make sure that
the voltage and frequency listed on the
rating label correspond with the
household electrical supply. This data
must correspond to prevent injury and
appliance damage. Consult a qualified
electrician if in doubt.
~
Be certain your appliance is
properly installed and grounded by a
qualified technician.
~
To guarantee the electrical safety of
this appliance, continuity must exist
between the appliance and an effective
grounding system. It is imperative that
this basic safety requirement be met. If
there is any doubt, have the electrical
system of the house checked by a
qualified electrician.
IMPORTANT SAFETY INSTRUCTIONS
~
power cord and gas piping do not
come into contact with any portion of
the combiset which may become hot
during use.
~
connect this appliance to electricity.
Extension cords do not guarantee the
required safety of the appliance.
~
has been properly installed in the
countertop.
~
damaged cord or plug, or if the
appliance has been damaged in any
manner. Contact Miele's Technical
Service Department.
~
replaced by Miele original spare parts
only. Only with these parts can the
manufacturer guarantee the safety of
the appliance.
~
outer casing of the appliance.
~
warranty repairs should only be
performed by a Miele authorized
service technician. Otherwise the
warranty is void.
Install the appliance so that the
Do not use an extension cord to
Do not operate the appliance until it
Do not operate any appliance with a
Defective components should be
Under no circumstance open the
While the appliance is under
5