Boiling Water; Heating Water - Beem 01108 Instruction Manual

EN
Constant Mode (Picture A2)
1. Flip the lever all the way back. It locks in place in this position. The discharge tap opens and water
flows out.
2. Let go of the lever again and tip it forwards (do not press it down) when the quantity of water
you want has been removed. The discharge tap closes again.
Preparation
PLEASE NOTE!
• Do not operate the device without water. If this does happen, the heating element of the
device switches off automatically (protection against running dry). The dry-running pro-
tection control lamp
5 – 10 minutes before water is poured in and the device is used again.
If water needs to be added, switch off the device, pull the mains plug out of the socket and
allow the device to cool down for a few minutes. When opening the lid (4), use potholders
or similar gloves and be careful.

Boiling Water

1. Pour water into the water reservoir (7) (see the "Operation" chapter – "Filling the Water
Reservoir").
2. Turn the thermostat control (9) clockwise to the
start boiling the water. The heating control lamp
until it has completely evaporated.

Heating Water

If water is just to be heated, boil the water once (see the "Preparation" chapter – "Boiling Water").
As soon as it boils, use the thermostat control (9) to select the setting you want. The thermostat
enables individual, infinite setting of the water temperature.
Interval Boiling
For an energy-saving way to boil water, it is advisable to choose the interval boiling setting. Here
the thermostat regulates the supply of power as required. The device switches off the heating
element once the water has boiled and switches it back on again as soon as the temperature of
the water drops.
For this purpose, boil the water once (see the "Boiling Water" section). As soon as it boils, turn the
thermostat control (9) down so that the heating control lamp
As soon as the thermostat switches the heating element back on, the heating control lamp
lights up again.
lights up. In this case, allow the device to cool down for around
position to switch on the device and
(11) lights up. The water carries on boiling
(11) goes out.
26